Please ensure the following plumbing and electrical requirements are ready at the site before our service technician arrives to set up your Krysto RO system:
A standard 3-pin, 220-240V AC power socket within 1.5 metres of the machine location.
A source water line tap within 1 metre. Ideal incoming pressure should be between 0.3 to 3.0 kg/cm².
Adequate wall or counter space away from direct sunlight, freezing areas, or hot kitchen stoves.
An open drain or sink within 2 metres. We recommend setting up a clean bucket to collect and repurpose the drain water!
Fully Automatic Control: The unit automatically restarts when water levels drop and shuts off once the storage tank is completely full.
🌱 Every Drop Counts: For every litre of pure water produced, your Krysto RO system safely separates concentrated impurities into the reject line. Do not let this water go down the drain. Direct the reject tube into a collection bucket. It is perfectly suited for household mopping, cleaning utensils, flushing toilets, or watering your garden plants. Our installation technicians will happily help you route your drain tube into a collection container upon request.
| Component | Replacement Cycle |
|---|---|
| Sediment & Carbon Pre-filters (Stages 1, 2, 3) | Every 9 months |
| RO Membrane (Stage 4) | 12 to 18 months depending on water quality and flow rate |
| Post-Carbon Filter/Mineral cartridge (Stage 5) | Every 9 months |
| Tank Sanitisation | Every 9 months |